F003 - Pilot Voltage: Low - Minimum Required Error Codes

Pilot Voltage: Low - `F003`

Triggered and sent to the CPO in the event that the pilot signal is out of range on the low side. This occurs when the pilot signal is below 5.47VDC during active charging.

In the StatusNotification.req use the info field to provide the measured proximity value at the time of failure. The units shall be VDC.

EVSE Display Requirements

Prompt the user that an error has occured, and provide instruction to try again.

The instruction to try again should suggest confirming a properly seated connector.

If contacting Customer Service, reference error code: F003.

Sample Message

[
    2,
    "12345",
    "StatusNotification",
    {
		"connectorId": 1,
		"errorCode": "OtherError",
		"info": "5.00",
		"status": "Finishing",
		"timestamp": "2022-06-10T14:51:17Z",
		"vendorId": "com.evgo.mrec",
		"vendorErrorCode": "F003"
    }
]